Linux interface RX Packet Dropped with LACP and not doing loadbalacing

OS: CentOS 6.6 / 64bit / Kernel 2.6.32-504.30.3.el6.x86_64 I have bond0 interface with following configuration. Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009) Bonding Mode: IEEE 802.3ad Dynamic link aggregation Transmit Hash Policy: layer2 (0) MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 802.3ad info LACP rate: slow Aggregator selection policy (ad_select): stable Active Aggregator Info: Aggregator ID: 7 Number of ports: 2 Actor Key: 17 Partner Key: 3 Partner Mac Address: a4:56:30:c6:0d:00 Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 2 Permanent HW addr: 9c:8e:99:0d:1a:f2 Aggregator ID: 7 Slave queue ID: 0 Slave Interface: eth1 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 2 Permanent HW addr: 9c:8e:99:0d:1a:f4 Aggregator ID: 7 Slave queue ID: 0 modprobe.conf alias bond0 bonding options bond0 mode=4 miimon=100 Cisco switch config: interface Port-channel1 description Linux-bond0 switchport access vlan 10 interface GigabitEthernet0/7 switchport access vlan 10 spanning-tree portfast spanning-tree guard root channel-protocol lacp channel-group 1 mode active ! interface GigabitEthernet0/8 switchport access vlan 10 spanning-tree portfast spanning-tree guard root channel-protocol lacp channel-group 1 mode active ! # Issue I am getting RX packet drop on bond0 and eth0 interface on Linux ( but not on eth1) bond0 : RX packets:575214161 errors:0 dropped:6407 overruns:0 frame:0 eth0 : RX packets:573623915 errors:0 dropped:6410 overruns:0 frame:0 eth1 : RX packets:1590356 errors:0 dropped:0 overruns:0 frame:0 I have check MRTG to see traffic flow and its around ~30mbps But interesting thing. I am seeing all 30mbps traffic on eth0, eth1 has few kbps traffic. That means my link is not doing load balancing right? cacti reporting following data. LACP should share traffic on both link right? eth0: 30mbps eth1: 600kbps