I have installed armbian on SD card and I cannot get no network. Neither ethernet, neither wireless.
Only thing I managed is to connect to it via serial port.
Here is some information about my network im connected to:
Gateway: 192.168.8.1
Dhcp: 192.168.8.1
DNS: 192.168.8.1
Network DNS always assigns addresses from 100-200
root@orangepizero:~# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
0.0.0.0 - 255.255.255.0 ! 0 - 0 -
192.168.8.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
root@orangepizero:~# cat /etc/network/interfaces
auto lo
iface lo inet loopback
iface eth0 inet dhcp
gateway 192.168.8.1
netmask 255.255.255.0
auto wlan0
iface wlan0 inet dhcp
wpa-ssid *****
wpa-psk *****
I have tried assigning static addresses, and some other tips I found on the internet, and I had no success. Device is still without connection.
Here is my current ifconfig eth0 (although it has ip that I placed, it is not connected to the router)
eth0 Link encap:Ethernet HWaddr e6:f5:19:a6:1b:e6
inet addr:192.168.8.121 Bcast:192.168.8.255 Mask:255.255.255.0
inet6 addr: fe80::e4f5:19ff:fea6:1be6/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:237 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:10602 (10.3 KiB)
Interrupt:114
Asked by Marko
(23 rep)
Apr 1, 2017, 05:32 PM
Last activity: May 28, 2025, 04:05 PM
Last activity: May 28, 2025, 04:05 PM