A solution to bridge wlan0 or permit to use the same lan for tap/br?

I have a tftp server on lan 192.168.0.0/24 I want a qemu vm reach it, with ethernet is simple a) First create br0 MAC1="52:54:$(dd if=/dev/urandom count=1 2>/dev/null | md5sum | sed 's/^\(..\)\(..\)\(..\)\(..\).*$/\1:\2:\3:\4/')"; nmcli con add ifname br0 type bridge con-name br0 bridge.mac-address $MAC1 b) then add eth0 as slave, then you can add vnet* or tap* interfaces with qemu or libvirt With wlan is impossible brctl addif br0 wlan1 can't add wlan1 to bridge br0: Operation not supported nmcli fail also with timeout So I have two solutions, create a "virbr" with libvirt and the use iptables rules for natting it, but the virbr must have a different lan address (192.168.1.0/24 or 10.2.1.0/24 or whatever you want but not an address of ip range used by wlan because exit with errors) or create an empty br0 with network-manager and then assign a ip address to it and with iptables route to wlan0 iptables -A FORWARD -i br0 -o wlan1 -j ACCEPT iptables -A FORWARD -i wlan1 -o br0 -m state --state NEW,RELATED,ESTABLISHED -j ACCEPT iptables -t nat -A POSTROUTING -o wlan1 -j MASQUERADE but when I try to get a dhcp address from 192.168.0.0/24 lan it fail. Any advice to use 192.168.0.0/24 ip for wlan "bridge"? Thanks Edit: the iw command to "enable" the wlan0 as slave fail iw dev wlan1 set 4addr on command failed: Operation not supported (-95) Another thing: today I have installed VirtualBox on Debian 12 and using wifi bridge work, I can ping the vm using the same ip class of wlan0 wifi (88x2bu driver), but ip addr and ip link sh don't report interface, where is the bridge?